Useful Juniper Netscreen Commands

Advertisements

This article is aimed at sharing some of key commands used for Juniper Netscreen platform.

The “Command” and “Description” has been enlisted under every feature set as below –

INTERFACE

COMMAND

DESCRIPTION

 get counter statistics  Show interface statistics (CRC errors etc)
 get interface trust port phy  Show physical ports for a certain zone
 get driver phy  Show all link states of interfaces
 get counter statistics interface ethernet3  Show hardware stats on interface
 set interface [interface] no-subnet-conflict-check  Allows you to configure multiple interfaces in the same IP broadcast domain.

CURRENT SETTINGS / VALUES

COMMAND

DESCRIPTION

get envar  get environment variable
 get config  get device configuration
 get system  get system information
 get arp  get arp cache
 get route  get routing table
 get system | i Box  get port-mode
 get alg h323 counters  get the ALG counters
 get alg  get status of ALGs (disabled or enabled
 get sys-cfg  get default settings for the device
 get sys scale  get basic system limits
 get debug  get currently enabled debug level
 get tcp  get system socket information

NAT – Juniper Comands

COMMAND

DESCRIPTION

 get mip  get mip (nat)
 get vip  get vip (nat)
 get nat cookie  get show nat cookies

 

STATISTICS / PERFORMANCE

COMMAND

DESCRIPTION

 get perf cpu detail  get cpu performance
 get session info  get load on firewall
 get counter flow  Show flow stats (fragmentation etc)
 get counter screen  Show screen stats (SYN Floods etc)

 

VPN

COMMAND

DESCRIPTION

 clear ike-cookie [gateway ip]  clear ike cookies
 clear sa [id]  clear sa
 get vpn  show vpns

 

NSRP

COMMAND

DESCRIPTION

 get nsrp cluster  Show cluster info
 get nsrp monitor  Show list of monitored interfaces
 get nsrp vsd id 0  Show VSD id 0
 get counters ha  Show HA interface hardware counters
 exec nsrp sync global-config check-sum  Allows you to see if the cluster configs are syncronised
 exec nsrp sync global save  Sync’s the nodes.A reboot is required to complete the update.
 exec nsrp vsd-group 0 mode  Fails over the cluster. Run this command on the Master node.

 

IGMP

COMMAND

DESCRIPTION

 set interface ethernet0/1 igmp router  set interface ethernet0/1 igmp router
 get vrouter trust-vr protocol pim   get the multicast sources visible to your ScreenOS device

 

MISC

COMMAND

DESCRIPTION

 set exec port-mode  set the port mode
 set flow tcp-mss 1460  sets the MSS

Related – CISCO AND HUAWEI EQUIVALENT COMMANDS

REFERENCE –

https://www.fir3net.com/Firewalls/Juniper/juniper-commands.html

Related Posts

About The Author

Add Comment

Social Media Auto Publish Powered By : XYZScripts.com
Select your currency
USD United States (US) dollar